ACiQ mini split error code F9

Common causes

• A failed module sensor or board.

How to fix it yourself

Do the reset and the visual checks, but the underlying repair needs a technician with a meter and the service manual.

1. Reset the system: switch the breaker (or the outdoor disconnect) off, wait a full five minutes so the boards fully discharge, then switch it back on and restart from the remote.

Switch off power at the breaker before opening either unit. Capacitors in the outdoor unit hold a charge for several minutes after power is cut.

When to call a technician

Board-level fault.

Which ACiQ units show F9

This page applies to ACiQ Standard single-zone (ACiQ-09Z-HP…B / W-HP) and multi-zone and K-series (ACiQ-K09W-HP…, SZDM / WHP / KZHP) units on the K-series (ACiQ-K09W-HP…, TCL-built). ACiQ's own documentation lists F9 as "Module test circuit temperature fault", the same definition used across the TCL platform it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.

Where ACiQ shows this code

K-series (ACiQ-K09W-HP…, TCL-built): The indoor display shows the code in place of the set temperature. E codes are faults: something has failed and needs diagnosis. P, H, d and F codes are protections: the system stopped or throttled itself to prevent damage, and many clear on their own once conditions return to normal.

Other ACiQ codes

Same part of the system as F9:

All ACiQ error codes

F9 on other brands

The same characters do not always mean the same thing. Check the brand on your unit.

• Blueridge F9 High discharge temperature frequency limiting (protection)
• Zone Air F9 Module test circuit temperature fault