Blueridge mini split error code F9
High discharge temperature frequency limiting (protection).
- TypeProtection
- SystemCompressor / inverter
- Can I fix it?Usually a homeowner fix
- Applies toBMKH series (Gree-built)
What F9 means on a Blueridge
The compressor is being slowed because its discharge temperature is climbing. The unit keeps running at reduced output.
On this platform, F9 is a protection: the system stopped or throttled itself to prevent damage; many clear on their own once conditions return to normal.
Common causes
- Low refrigerant charge.
- A dirty outdoor coil.
- Extreme heat.
How to fix it yourself
You can almost always clear this yourself with the steps below.
- Look at the outdoor unit: clear leaves, cottonwood fluff, snow or ice from the coil and make sure the fan can spin freely and nothing is stacked against the cabinet.
- If it happens often in mild weather, suspect low charge (see E4).
- Anything inside the refrigerant circuit (sensors are fine, but valves, compressors and leaks are not) needs EPA-certified refrigerant handling. That is a technician job.
Switch off power at the breaker before opening either unit. Capacitors in the outdoor unit hold a charge for several minutes after power is cut.
When to call a technician
Frequent F9 in mild weather should get a charge check.
Which Blueridge units show F9
This page applies to Blueridge BMKH wall-mount, floor-ceiling and multi-zone (2016 and later) and BMY / BMX S-series single-zone (2023 and later) units on the BMKH series (Gree-built). Blueridge's own documentation lists F9 as "High discharge temperature frequency limiting (protection)", the same definition used across the Gree platform it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.
Where Blueridge shows this code
BMKH series (Gree-built): The code shows on the indoor unit's display in place of the temperature. If the display is off, press the Light button on the remote. Some models also count out the code as indicator blinks. E codes are system protections and faults, F codes are mostly sensor faults, H codes are outdoor and compressor protections, U codes are motor and valve faults, and P codes are power-supply faults.
Other Blueridge codes
Same part of the system as F9:
F9 on other brands
The same characters do not always mean the same thing. Check the brand on your unit.
- Gree F9 High discharge temperature frequency limiting (protection)
- Zone Air F9 Module test circuit temperature fault
Questions people ask
Can I reset a Blueridge F9 code myself?
Yes. Turn the system off at the breaker for five minutes, then restart it. If F9 comes back, the fault is real and needs the checks above.
Is it safe to keep running a Blueridge showing F9?
Not repeatedly. A protection code means the unit stopped itself to prevent damage, and resetting it over and over can turn a cheap repair into a compressor failure. Reset once, check the basics, and stop if it returns.
Do I need a technician for Blueridge F9?
You can almost always clear this yourself with the steps below. Frequent F9 in mild weather should get a charge check.
Sources
- Blueridge Installation and Owner's Manual (BMKH, 11/2016 and 01/2017 editions), Diagnostic Codes
- Blueridge BMKH Floor-Ceiling User and Install Manual (12/2023), error code table
- Blueridge BMY19 Series Owner's Manual and DIY Single Zone Installation Manual (2020), Midea document CS78421-548-754 (same manual family as Pioneer WYT)
Updated September 2026. Codes and definitions vary by model year. If your manual disagrees with this page, your manual wins. Send a correction.