Mitsubishi Electric mini split error code U8
Outdoor fan motor fault.
- TypeFault
- SystemFan motor
- Can I fix it?Homeowner checks, then maybe a tech
What U8 means on a Mitsubishi Electric
The outdoor fan is stalled, failing, or not reporting its speed. The compressor stops.
On this platform, U8 is a fault: something has failed or is disconnected and needs diagnosis.
Common causes
- Ice, snow, leaves or debris blocking the fan.
- A failed motor.
- A loose fan connector.
How to fix it yourself
Work through the checks below first; they resolve most cases. If they do not, the repair itself may need a technician.
- Reset the system: switch the breaker (or the outdoor disconnect) off, wait a full five minutes so the boards fully discharge, then switch it back on and restart from the remote.
- Look at the outdoor unit: clear leaves, cottonwood fluff, snow or ice from the coil and make sure the fan can spin freely and nothing is stacked against the cabinet.
- With power off, spin the fan by hand; it should turn freely.
- Reseat the fan motor connector.
Switch off power at the breaker before opening either unit. Capacitors in the outdoor unit hold a charge for several minutes after power is cut.
When to call a technician
Fan motor replacement by a technician if it spins freely but the code persists.
Which Mitsubishi Electric units show U8
This page applies to Mitsubishi Electric M-Series (MSZ), Mr. Slim (PKA/PCA), Hyper-Heating H2i and MXZ multi-zone units. Mitsubishi Electric's own documentation lists U8 as "Outdoor fan motor fault", the same definition used across the Mitsubishi Electric it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.
Where Mitsubishi Electric shows this code
Wall units without a wired controller signal a fault by blinking the operation indicator lamp; the code itself shows on a wired controller (MHK/PAR series) or on the wireless remote after entering its check mode (see your manual). On the outdoor unit, the control board LEDs blink the same code. P codes are indoor-unit faults, E codes are communication faults, F codes are outdoor-unit faults and U codes are outdoor-unit and compressor faults.
Other Mitsubishi Electric codes
U8 on other brands
The same characters do not always mean the same thing. Check the brand on your unit.
- Blueridge U8 Indoor fan (PG motor) zero-crossing detection error
- Trane U8 Outdoor fan motor fault
Questions people ask
Can I reset a Mitsubishi Electric U8 code myself?
Yes. Turn the system off at the breaker for five minutes, then restart it. If U8 comes back, the fault is real and needs the checks above.
Is it safe to keep running a Mitsubishi Electric showing U8?
The unit will usually refuse to run, or run with reduced output, until the fault is cleared. Repeated resets do not fix anything and can mask a problem that is getting worse.
Do I need a technician for Mitsubishi Electric U8?
Work through the checks below first; they resolve most cases. If they do not, the repair itself may need a technician. Fan motor replacement by a technician if it spins freely but the code persists.
Sources
- Mitsubishi Electric M-Series and Mr. Slim service manuals (self-diagnosis tables)
Updated September 2026. Codes and definitions vary by model year. If your manual disagrees with this page, your manual wins. Send a correction.