DIY HVAC Tools

Concord mini split code AP

Wi-Fi pairing (access point) mode.

  • TypeStatus, not a fault
  • SystemDisplay
  • Can I fix it?Usually a homeowner fix

What AP means on a Concord

The unit's Wi-Fi module is broadcasting its own network so the app can connect and configure it. It shows AP during setup, and sometimes after a power interruption if the module reboots.

On this platform, AP is a status, not a fault: the unit is telling you what it is doing; nothing is wrong.

What to do

You can almost always clear this yourself with the steps below.

  1. Finish pairing in the manufacturer's app, or wait; the unit exits AP mode on its own after several minutes.
  2. To force it out, turn the unit off and on with the remote.

When to call a technician

This is not a fault. No technician is needed unless it will not clear.

Which Concord units show AP

This page applies to Concord 4DHV outdoor with DWH wall-mount indoor (2016 and later) units. Concord's own documentation lists AP as "Wi-Fi pairing (access point) mode", the same definition used across the Midea platform (classic codes) it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.

Where Concord shows this code

The code appears on the indoor unit's LED display in place of the set temperature. Some models also blink the indicator lamps in a pattern that matches the code. E codes are faults in the indoor unit or its communication link, F codes are faults on the outdoor side, and P codes are protections: the outdoor unit has stopped itself to prevent damage. EC is the refrigerant leak check.

Other Concord codes

Same part of the system as AP:

dFDefrost cycle runningCLFilter cleaning reminder
E0Indoor unit EEPROM parameter errorE1Communication error between indoor and outdoor unitsE2Zero-crossing signal detection errorE3Indoor fan speed out of control (indoor fan motor fault)E4Indoor room temperature sensor (T1) open or short circuitE5Evaporator coil temperature sensor (T2) open or short circuitECRefrigerant leak detected (low refrigerant charge)F0Overload current protection (compressor over-current)

All Concord error codes

AP on other brands

The same characters do not always mean the same thing. Check the brand on your unit.

Questions people ask

Is AP on a Concord mini split an error?

No. AP is a status message: wi-Fi pairing (access point) mode. The unit's Wi-Fi module is broadcasting its own network so the app can connect and configure it.

Do I need a technician for Concord AP?

You can almost always clear this yourself with the steps below. This is not a fault. No technician is needed unless it will not clear.

Sources

  • Allied Air 4DHV Mini-Split Series Service Manual 508067-01 (2016), Table 14 Indoor and Outdoor Unit Error Codes

Updated September 2026. Codes and definitions vary by model year. If your manual disagrees with this page, your manual wins. Send a correction.