Panasonic mini split error code F11

Common causes

• A stuck reversing valve.
• A failed solenoid coil or wiring.
• Low charge.

How to fix it yourself

Do the reset and the visual checks, but the underlying repair needs a technician with a meter and the service manual.

1. Reset the system: switch the breaker (or the outdoor disconnect) off, wait a full five minutes so the boards fully discharge, then switch it back on and restart from the remote.
2. Switch between Cool and Heat and listen for the valve shifting.
3. Anything inside the refrigerant circuit (sensors are fine, but valves, compressors and leaks are not) needs EPA-certified refrigerant handling. That is a technician job.

Switch off power at the breaker before opening either unit. Capacitors in the outdoor unit hold a charge for several minutes after power is cut.

When to call a technician

Valve replacement is a technician job.

Which Panasonic units show F11

This page applies to Panasonic Exterios, ClimaPure and Multi-zone (CU-xE) units. Panasonic's own documentation lists F11 as "Four-way (reversing) valve switching fault", the same definition used across the Panasonic it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.

Where Panasonic shows this code

The indoor unit blinks its Timer lamp when a fault is stored. To read the code, point the remote at the unit and hold the CHECK button (on the back of the remote, under the flap on most models) for about 5 seconds until -- shows, then press the temperature up or down button; each press shows a code, and the unit beeps continuously (not a short beep) when the code shown is the stored fault. H codes are faults (a sensor, motor or board that needs attention). F codes are protections: the outdoor unit stopped itself because of pressure, temperature or current.

Other Panasonic codes

Same part of the system as F11:

All Panasonic error codes