LG mini split error code CH10

Common causes

• Debris jamming the blower wheel.
• A dirt-caked wheel.
• A failed BLDC fan motor or loose connector.
• A failed fan drive on the board.

How to fix it yourself

Work through the checks below first; they resolve most cases. If they do not, the repair itself may need a technician.

1. Reset the system: switch the breaker (or the outdoor disconnect) off, wait a full five minutes so the boards fully discharge, then switch it back on and restart from the remote.
2. With power off, remove the filters and spin the blower wheel by hand; it should turn freely.
3. Clean the wheel and reseat the motor plug.
4. Restart and listen for a hum without rotation.

Switch off power at the breaker before opening either unit. Capacitors in the outdoor unit hold a charge for several minutes after power is cut.

When to call a technician

A fan motor is a moderate DIY swap; if it spins freely and the plug is tight, the board is the suspect.

Which LG units show CH10

This page applies to LG Art Cool, Standard, Mega and Multi F units. LG's own documentation lists CH10 as "Indoor fan motor fault (locked or no feedback)", the same definition used across the LG it is built on. If your unit shows a code with a different shape (for example a four-character code, or a plain number), it is from a different table; use the lookup with your exact code.

Where LG shows this code

The indoor display shows CH followed by a number (CH05, CH38). Units without a display blink the indicator lamps in a pattern; the outdoor board LEDs blink the same number. If someone tells you 'CH 5', that is CH05. CH01 to CH12 are indoor-unit faults, CH21 to CH29 are inverter and compressor faults, CH32 to CH38 are refrigerant-side protections, CH40 to CH48 are outdoor sensors, and CH51 to CH73 are outdoor-unit system faults.

Other LG codes

Same part of the system as CH10:

All LG error codes